I see what you're referencing.... but I'm not sure I understand how to implement it. How does it know what register I'm trying to write to if I don't specify the address?
When reading use an address byte. When writing do not use an address byte.
The following snip-it works:
'========================[Write/Read data to/from FM module ]=====================
Write_ConfigRegs: ' Write Data to Configure Registers
I2COUT SDA, WrFM, [Conf2.Highbyte, Conf2.Lowbyte, Conf3.Highbyte, Conf3.Lowbyte, Conf4.Highbyte, Conf4.Lowbyte, Conf5.Highbyte, Conf5.Lowbyte, Conf6.Highbyte, Conf6.Lowbyte]
I2CIN SDA, RdFM, 0, [Status1,Status2,status3,status4]
DEBUG CRSRXY,10,1,"Status : ", HEX2 status1, " ", HEX2 status2, " ", HEX2 status3, " ", HEX2 status4, " "