Go Down

Topic: How to weatherproof sensors (Read 1 time) previous topic - next topic

Cerin


If you seal the sensor , so that it is waterproof,   then the soil moisture and humidity won't be able
to get into it.   
I suspect that a completely waterproof solution is not what you actually want, for your stated application.


True. I was referring to the above-ground part of the sensor, especially the plug. I'm not too worried about the below-ground parts, as long as the leads are gold-plated or similarly protected against corrosion.

Chagrin

I keep a two part epoxy (as used with fiberglass) for problems like this. The epoxy can be thinned down with denatured alcohol if necessary and in this case would probably result in a coating similar to what arbutus is describing. Don't expect to remove the plug afterward though ;)

Shelf life is very long (years). Tons of uses as either a glue or coating. You might find it at a auto store -- just remember it's epoxy and not polyester resin which is generally just a huge PITA.

overkillthemighty

Just my 2 cents... Use capacitance to measure moisture, this allows you to completely seal the unit and you don't have to use expensive metals for the tester. Also, use a decent connector and dielectric grease in the connector. The grease is the kind they use to keep the elements out of spark-plugs and buried telephone line junctions and such.

Cerin


Just my 2 cents... Use capacitance to measure moisture, this allows you to completely seal the unit and you don't have to use expensive metals for the tester. Also, use a decent connector and dielectric grease in the connector. The grease is the kind they use to keep the elements out of spark-plugs and buried telephone line junctions and such.


Does anyone sell these at a reasonable price in a form I can easily connect to an Arduino's ADC port? Googling doesn't find much, and the few I can find, like this, don't have any price listed...which usually means they're insanely expensive. I have a budget of a couple hundred dollars, and it looks like a single "good" capacitive soil moisture sensor may well cost much more than that.

Go Up