Go Down

Topic: Angular position sensor? (Read 6 times) previous topic - next topic

Chagrin

Couple more links: http://www.openservo.org/ (see: http://www.openservo.com/StepByStep) and http://code.google.com/p/zosupermodified/

These designs are intended to replace the control board inside an RC servo to give it full positional feedback. The "openservo" hardware is available for purchase but the "supermodified" hardware appears to have fallen off the internet unfortunately :(


louarnold


Couple more links: http://www.openservo.org/ (see: http://www.openservo.com/StepByStep) and http://code.google.com/p/zosupermodified/

These designs are intended to replace the control board inside an RC servo to give it full positional feedback. The "openservo" hardware is available for purchase but the "supermodified" hardware appears to have fallen off the internet unfortunately :(



Thanks, I bookmarked all of them for later use. There is clearly much I don't know and I need to read the existing documentation. (Yawn!)

Lou.

zoomkat

Quote
This is for several uses on a robot. I am looking for a sensor that provides a code for the angular position of a shaft - such as a steering shaft or a disk that rotates a camera mounted on it. The idea is to determine the angle when the shaft is NOT turning. This is not for detecting high-speed changes. What is available?


The total rotation of the range needs to be established for a good solution suggestion. If the stearing shaft only rotates ~45 deg., then a linkage to a pot might suffice. If the cam rotates only 360 deg in range, then a pot might also do using simple gears or a pully setup. 
Consider the daffodil. And while you're doing that, I'll be over here, looking through your stuff.   8)

louarnold


Quote
This is for several uses on a robot. I am looking for a sensor that provides a code for the angular position of a shaft - such as a steering shaft or a disk that rotates a camera mounted on it. The idea is to determine the angle when the shaft is NOT turning. This is not for detecting high-speed changes. What is available?


The total rotation of the range needs to be established for a good solution suggestion. If the stearing shaft only rotates ~45 deg., then a linkage to a pot might suffice. If the cam rotates only 360 deg in range, then a pot might also do using simple gears or a pully setup. 

Of course - a single turn pot. Cheap, simple and robust. That was so obvious it never ocurred to me.
Thank you.

amendis

Seems to be a common problem, measuring angles, specially when it comes to making mobile robots. At the end I had to make my own board, now selling it..I have a few boards on my website ,http://www.asquared.cc/products/

louarnold


Seems to be a common problem, measuring angles, specially when it comes to making mobile robots. At the end I had to make my own board, now selling it..I have a few boards on my website ,http://www.asquared.cc/products/

Very nice. I bookmarked the web page.
Thanks very much.

Go Up
 

Quick Reply

With Quick-Reply you can write a post when viewing a topic without loading a new page. You can still use bulletin board code and smileys as you would in a normal post.

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.
Name:
Email:

shortcuts: alt+s submit/post or alt+p preview