Go Down

Topic: Create Arudino UNO board (Read 1 time) previous topic - next topic

ujjwalbsoni20032003

Hi,

I want to develop my own Arudino UNO board following below Article.

http://www.instructables.com/id/How-to-make-your-own-Arduino-board/?ALLSTEPS

I cannot find interfacing for USB, any idea how this can be done ?

Thanks,

Ujjwal Soni

johnwasser

Use a USB to TTL Serial cable or board, sometimes called an FTDI cable.
Send Bitcoin tips to: 1L3CTDoTgrXNA5WyF77uWqt4gUdye9mezN
Send Litecoin tips to : LVtpaq6JgJAZwvnVq3ftVeHafWkcpmuR1e

FelixFelicis

I would suggest you to use the UNO board to burn the program. You have too buy a FTDI breakout board which will cost you around 14-15$.

CrossRoads

Other USB interface options are:
Mikroelectronika MIKROE-483
http://www.mouser.com/ProductDetail/mikroElektronika/MIKROE-483/?qs=%2fha2pyFaduiYF24RmhpFb%2fIWf1yag44MUlcjvQN8IKu%2fLeA1aA%252bcGO%252bFHzoFLaES

CP2102 modules found on e-bay.
Look for units that have holes along the side where some signals are brought out. You will do a simple mod to cut the RST trace going to the end header pin and wire the pin to the DTR hole instead. This will allow software resets during downloads.

Having USB interface capability can be very handy during sketch debugging.
Designing & building electrical circuits for over 25 years.  Screw Shield for Mega/Due/Uno,  Bobuino with ATMega1284P, & other '328P & '1284P creations & offerings at  my website.

Go Up