Pages: [1]   Go Down
Author Topic: Total Newb question, SHT75 Temp/Humidity sensor. How to?  (Read 2456 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 42
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

http://www.sensirion.com/fileadmin/user_upload/customers/sensirion/Dokumente/Humidity/Sensirion_Humidity_SHT7x_Datasheet_V5.pdf

So I'm reading this. Say I wanted to use this without a breakout board on an Arduino. VDD goes to a 3.3 or 5 V pin, ground goes to a ground pin, but are there any pins with a 10k ohm pull up resistor built in? What pin would the serial clock pin go to? Basically how would a complete newb hook this up to an Arduino, step by step.

What kind of connectors would I use for the pins on the sensor (it explicitly says no soldering).
Logged

Georgina Ontario
Offline Offline
Sr. Member
****
Karma: 5
Posts: 437
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Did it occur to you to do a google search?

http://www.google.ca/#hl=en&sclient=psy-ab&q=SHT7X+arduino&oq=SHT7X+arduino&gs_l=hp.3..0i30.1523.8983.0.12426.13.7.0.6.6.0.91.546.7.7.0...0.0...1c.VrYXfGV2izY&pbx=1&bav=on.2,or.r_gc.r_pw.r_qf.,cf.osb&fp=e3ea13f2fea9acba&biw=1461&bih=790

Which leads here?

http://arduino.cc/playground/Code/Sensirion

As for step by step -- if you are asking us to design your system and write codes -- the rate of the "old-timers" can seem awful prohibitive. May I send you a rate sheet?  smiley-evil

Logged

Just another Hacker

Offline Offline
Newbie
*
Karma: 0
Posts: 42
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Will, yes, I did a google search, that's how I found the specs for the sensor.

I don't need help with code. My brother is a programmer, all he needs is the example code which I also found on google.

I was looking for help with the physical hookup to the arduino. Reading the code, I now see the pinouts.
Logged

Pages: [1]   Go Up
Jump to: