Go Down

Topic: Breadboarduino (Read 511 times) previous topic - next topic

xvjeko

Jul 25, 2012, 10:25 am Last Edit: Jul 25, 2012, 01:39 pm by xvjeko Reason: 1
Hello, i just put my atmega328-pu with an arduino bootloader on a breadboard.
I connected it based on the examples given here on arduino's site, and i am using an UART device for the serial communication.
The chip is running blink example. How to upload the chip because i get the following message:
Code: [Select]
avrdude: stk500_getsync(): not in sync: resp=0x00
avrdude: stk500_disable(): protocol error, expect=0x14, resp=0x51


thanks

A little more information would be helpful.

Either your bootloader did not take (No blink from D13/PB5 when powered) or communication issues with the USB/TTL device (reset cap not installed).  Both of those will produce your error and vastly different solutions.
http://www.spcomputing.com

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy