Pages: [1]   Go Down
Author Topic: Breadboarduino  (Read 451 times)
0 Members and 1 Guest are viewing this topic.
Europe
Offline Offline
Full Member
***
Karma: 0
Posts: 104
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hello, i just put my atmega328-pu with an arduino bootloader on a breadboard.
I connected it based on the examples given here on arduino's site, and i am using an UART device for the serial communication.
The chip is running blink example. How to upload the chip because i get the following message:
Code:
avrdude: stk500_getsync(): not in sync: resp=0x00
avrdude: stk500_disable(): protocol error, expect=0x14, resp=0x51

thanks
« Last Edit: July 25, 2012, 06:39:30 am by xvjeko » Logged

California
Offline Offline
God Member
*****
Karma: 14
Posts: 629
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

A little more information would be helpful.

Either your bootloader did not take (No blink from D13/PB5 when powered) or communication issues with the USB/TTL device (reset cap not installed).  Both of those will produce your error and vastly different solutions.
Logged


Pages: [1]   Go Up
Jump to: