Go Down

Topic: Laser Harp Help? (Read 5464 times) previous topic - next topic


So, I can use the built in resistors and just use 8 33ohm resistors to limit the 5 volts from the arduino to each laser

Well 15mA through 33R will give you half a volt so I don't see why not.

However driving lasers is a bit tricky have you read this:-

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131