After a bit of digging I found a place for super cheap PCB manufacturing.http://www.oshpark.com/
"Is that what all my "stop mask" errors are? Silk screen that overlaps something? "Yep. Large qty of them will be the outlines around connectors for instance.
Quote from: CrossRoads on Sep 09, 2012, 12:32 am"Is that what all my "stop mask" errors are? Silk screen that overlaps something? "Yep. Large qty of them will be the outlines around connectors for instance.So then all the slik screen is going to make an error, since its all on the stop mask.
One debugging step I have learned the hard way is to view only layer 19 the unrouted layer. In a complex board you may not be able to see short unrouted air traces, by only showing the unrouted layer you of course can see them clearly if they are there.Unrouted traces can occur if you route by hand or auto so I think this is a good debugging step.wade
Please enter a valid email to subscribe
We need to confirm your email address.
To complete the subscription, please click the link in the
email we just sent you.
Thank you for subscribing!
via Egeo 16