Pages: [1]   Go Down
Author Topic: Possible problem with 1.0.1 sketch uploads with some shields  (Read 587 times)
0 Members and 1 Guest are viewing this topic.
0
Offline Offline
Newbie
*
Karma: 0
Posts: 19
Arduino controlled scanning...
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Let me apologize right now for cross-posting this, but I wasn't getting the attention of any of the crew that develops the IDE in the other location.  1.0 and 1.0.1 will not upload a sketch to a Mega board if the shield is installed.  The same sketch uploads fine in 22 and 23.  I think this is a possible problem and will surely be a hindrance to acceptance and newbies trying to get going in the Arduino world.  Read on:
http://arduino.cc/forum/index.php/topic,113749.0.html
Logged

Chile
Offline Offline
Edison Member
*
Karma: 35
Posts: 1251
Arduino rocks?
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Let me apologize right now for cross-posting this, but I wasn't getting the attention of any of the crew that develops the IDE in the other location.  1.0 and 1.0.1 will not upload a sketch to a Mega board if the shield is installed.  The same sketch uploads fine in 22 and 23.  I think this is a possible problem and will surely be a hindrance to acceptance and newbies trying to get going in the Arduino world.  Read on:
http://arduino.cc/forum/index.php/topic,113749.0.html


What error do you get? I was also receiving errors in the 1.0.1, and not in the 0023
Logged

My website: http://ried.cl

Pages: [1]   Go Up
Jump to: