Pages: [1]   Go Down
Author Topic: Cannibalizing Printer and Satellite Decoder for Spares.  (Read 552 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 2
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi people,

I am new to Arduino, I find it fantastic and less frustrating than the Board I had to use at University last term.

I have found some printers and a Satelite decoder at a relives house, and I plan to canibaliste them, my obvious targets being the motors, resistance and push buttons.

Is there anything of value I could get from them ?
I lost my tinkerer mojo because my Electronics module was just a pain and I couldn't afford the material, but with Arduino I can actually do something on the cheap and I feel like Cannibal this week smiley-wink
Logged

Global Moderator
Boston area, metrowest
Offline Offline
Brattain Member
*****
Karma: 443
Posts: 23837
Author of "Arduino for Teens". Available for Design & Build services. Now with Unlimited Eagle board sizes!
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Can probably grab the printer electronics too - should be a usable power supply, maybe optical sensors, who knows what else.
Satellide decoder - won't know until you open it.
Logged

Designing & building electrical circuits for over 25 years. Check out the ATMega1284P based Bobuino and other '328P & '1284P creations & offerings at  www.crossroadsfencing.com/BobuinoRev17.
Arduino for Teens available at Amazon.com.

Anaheim CA.
Offline Offline
Faraday Member
**
Karma: 44
Posts: 2811
...
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I just scrapped a satellite receiver last week... Got about 30 electrolytics all of which measured ok, 3 crystals (One a VCO) a bunch of inductors for switchers and a whole gang of other parts including a separate Mains to 12Vdc switching PSU. Given a little patience and a good soldering iron and a free evening. Lots of really useful parts. Switching power supplies for Printers are really nice as a buck mode switching regulator will take that 24Vdc @ 500 mA output from an HP Printer and deliver 2.1 A @ 5Vdc out (the missing .3 A @ 5Vdc is the loss due to the efficiency of the switcher) and the nicest part is that it only requires a $1.95 switcher from Ebay. I always keep 3 or 4 of these parts on hand just for that purpose.

Doc
Logged

--> WA7EMS <--
“The solution of every problem is another problem.” -Johann Wolfgang von Goethe
I do answer technical questions PM'd to me with whatever is in my clipboard

Offline Offline
Newbie
*
Karma: 0
Posts: 2
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Thank you everybody for the answer  smiley

I got a little impatient because my new iron and my tools where taking long to arrive so I decided to go medieval on the Satellite Dish decoder with a knife.   smiley-red

I netted a 160GB HD, A motor (handy for my arduino learning, don't need to buy one from store), a transformer circuit with 2,5/3/12V output, USB mate and a IR sensor (which I also failed to buy in store)

I am going to open the rest only after I get my tools and my iron.
Logged

Pages: [1]   Go Up
Jump to: