Hows this look for a start?
I'd buy one.
I came across this thread while trying to source the same thing. I've been told about a Mega screw shield herehttp://www.aqualed-light.com/?sec=home&id=1758You will have to run it through a translator if you don't understand Portuguese. I was trying to find an online shop so I didn't have to email for an invoice, but this is all I've found so far.
Main characteristics of Screw Shield for the Arduino Mega:-Works on any Arduino Mega 2560/ADK/1280/Other/Clones.-Can be stacked with other shields over.-All pins of the Arduino Mega are replicated by terminals with screws being so simple to make any link without welds.-Have extra for signs of terminals GND, 5V, 3.3 V and VIN in order to easily feed on other external circuits.General appearance:
Does anyone have a clue as to a shield for the mega that would allow a 40 pin cable, short but long enough to access the other I/O on the mega... I have an LCD (Itead) and a shield for my mega but there is NO access to anything under that shield...I would hate to make one... 40 dollars or so??? the time isn't an issue just a one of or two of circuit board is more than I want to pay. Any Idea's?Doc
Please enter a valid email to subscribe
We need to confirm your email address.
To complete the subscription, please click the link in the
email we just sent you.
Thank you for subscribing!
via Egeo 16