Go Down

Topic: DNP3 over serial port how to start ? (Read 1 time) previous topic - next topic

FrankRadio

Hi all!

What I want to do is easy
I want to wrote a DNP3 profile and use it like protocol over a serial link between a PC and a Arduino.

I'm trying to decode a comercial device that use DNP3 and it have a defined DNP3 profile.

like this:http://www.qtech.co.nz/site/qtechdata/files/Technical%20Manuals%20etc//DATRAN%20XL4%20DNP3%20RTU%20-%20Device%20Profile%20v1.pdf

Now from here to the serial stream...what I need to do? I can't found the skeleton of this protocol to use in a serial link.

Best Regards
Frank

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy