Go Down

Topic: Motor Shield R3 (Read 910 times) previous topic - next topic


Hi I've just put together a robot and Im using the Arduino Uno with the Motor Shield R3 and for the drive wheels I used the Tamiya gearbox specs are as follows :Typical operating voltage: 3 V
Free-run motor shaft speed @ 3V:
12300 rpm1
Free-run current @ 3V:
150 mA2
Stall current @ 3V:
2100 mA
Motor shaft stall torque @ 3V:
0.5 ozĀ·in3

The motor shield chip in the middle of the board is getting hot after a short period of time running the 2 motors im using a rechargable 9.6 v 1600mah battery pack for power source. Is there anything wrong with this setup?

Thanks, Shawn

michael shiloh

Are you providing 3V to Vmot?


I just have the vmotors hooked into the shields inputs how would I go about putting resistance into the the motors Im gonna re-route them through a bread board. Do know what resistors I would need to use?


I stitch the added pins are because the FTDI crisp is no mortal victimised on the R3. I did deed a substance somewhere that said the efferent shield was regardant harmonious with the R2 so I change the pins are not required.

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131