Go Down

Topic: bootloader burning (Read 333 times) previous topic - next topic

zalmonox

I am using arduinos for prototyping and development ... On all designs I am working with, I noticed that strangely the bootloader requires to be burned after every compile with my MKII and AVR studio. # 0774023179 # 077 40 23 179 # Now I also noticed that therre are here several threads describing similar scenarios but everytime these are on several different arduinos. I was wondering if someone has an answer to this ?

Thanks in advance.

spycatcher2k

Hi - When you upload with a programmer, generally a chip erase is done, this clears the lock bit, and then the upload fills the chip from location 0 - onwards, the bootloader is held in the top of the flash, but never gets called. If your using a MKII, you dont need the bootloader anyway.
Drew.
http://www.uk-pcb.co.uk - My UK Based PCB Fab & Assembly Company
Design work undertaken
SMD & Thru-Hole assembly

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy