Go Down

Topic: Arduino UNO R3 Data Type and Simulink via MATLAb 2012a (Read 1 time) previous topic - next topic

ziltu57

Hello everybody in forum,
I am getting a problem for Arduino UNO R3 in combine with ADXL335 accelerometer to make simulink block in Matlab 2012a. For example,  I have used Arduino Analog Input block and run it. The command was showing that the model downloaded successfully. Now my question is, did i able to read the Arduino UNO board? If yes means what should I do now? Please guide me any of you. Also another question is, how should i calibrate G value from the output data if data type is unit8 (49 51 53)?

rgds
Anam

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy