Go Down

Topic: Maxuino and max 5 (Read 210 times) previous topic - next topic

Qwertis

Apr 13, 2014, 11:42 am Last Edit: Apr 14, 2014, 03:18 pm by Qwertis Reason: 1
Hi!
I have a question:
I want to use maxuino to connect my arduino to max/msp.
When I want to control e.g. a servo motor it uses the [live.slider] object.
As you may know – the [live.slider] object exists only in max 6 – I have max 5…
Is there a way to replace [live.slider]? I already have tried [float] and [slider] but with no succes.
(I want to control through max/msp my arduinos the pwm ports and a stepermoter)


(second) Also, i found it strange that the green circle messages work, but the red ones don't…
If the slider and float doesn’t work, than (according to my ‘logic’) than a message object [analogWrite 9 0.5] should work – right?
But sadly it doesn’t. Can you tell me why?


My Arduino is connected correctly. I tested through Firmata_Test.exe (firmata.org) and everything works. The digital output works through maxuino – even at pin 9 (digital).
sorry for my english, i’m not a native speaker but I do my best :)
Thanks in advance for your help!
-Mark

Update: I also tried it on another arduino - that one it doesn't work also as it should..

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy