Pages: [1]   Go Down
Author Topic: Programming just once  (Read 291 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Karma: 0
Posts: 3
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

First I want to say that I posted this topic (,119955.0.html) and I made some progress but I have new issues now.

I am able to burn the bootloader using the arduino as isp. Then I use a FTDI board to program it. And it works, the problem is that when I want to program it again (or upload a new scketch) it gives me an avrdude get_sync error. But if I burn the bootloader again, it allows me to program it again just once. Anybody know what it could be?

It is all connected together (and after that I burn the bootloader and then the uploading works just once), so it should not be a connection issue, but so far I have no clue what it could be. I can work with the board but I want to avoid the bootloader burning every time.

Left Coast, CA (USA)
Offline Offline
Brattain Member
Karma: 362
Posts: 17305
Measurement changes behavior
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

My guess, and just a guess, is that the target board/circuit you are mounting the chip in after burning the bootloader is not handling the Arduino auto-reset pulse. Could you give more details about your target board and or the FTDI module and how you are wiring them up?


Pages: [1]   Go Up
Jump to: