So there may be an unknown internal connect?
Answer/Question on your first paragraph:see attachment!so if I connect the switch like in the attachment, I can to a hardware reset with the uC AND with the switch if I understood well?_________________________________________________________________________________________________________
Answer/Question on your second paragraph:I think I missunderstood you! you meant with "to send 3 commands for 3 chips" that when I send data to the first driver I have to send first his adress and then all HIS registers (with his own Shutdown register) with THEIR specific bits, then when I send data to the second driver I have to send first his adress and then his registers (with his own Shutdown register) etc?_________________________________________________________________________________________________________
In the end I have three methods to reset them??? :software with their own register, and hardware with a switch & with the uC?
Please enter a valid email to subscribe
We need to confirm your email address.
To complete the subscription, please click the link in the
email we just sent you.
Thank you for subscribing!
via Egeo 16