Pages: [1]   Go Down
Author Topic: Petty Coin Bank Design - Coin Dispenser. What should i use?  (Read 468 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 47
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hey Guys, need your advise on this...
Going straight ahead to the point, What can you suggest i can use for the movement of the Plate in the Coin Dispenser Design in the image?
I need a component that does a push-pull action based on the design inspired from this video:


Need your advise. smiley


* CoinDispenser.jpg (170.9 KB, 1077x768 - viewed 10 times.)
Logged

Massachusetts, USA
Offline Offline
Tesla Member
***
Karma: 202
Posts: 8716
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

If you HAVE to use a slider you can make it FAST with a solenoid or slow with a servo.

Another option is to put the hole in a disk and have a motor rotate the disk.  A notch on the side of the disk and a microswitch can be used to sense the stop position.
Logged

Send Bitcoin tips to: 1L3CTDoTgrXNA5WyF77uWqt4gUdye9mezN
Send Litecoin tips to : LVtpaq6JgJAZwvnVq3ftVeHafWkcpmuR1e

Pages: [1]   Go Up
Jump to: