Go Down

Topic: 10W RGB LED constant current drivers (Read 14905 times) previous topic - next topic


I was aiming for about 330-350mA but final circuit is more like 240mA.

That resistor and Vbe set the current. For 350ma, you need the resistor to be about 670mv / 350ma < 2ohm.

Linear constant current drives like yours are best for small power applications (<1amp in my view). Your circuit works, and I personally prefer the LM317 based solutions.

For higher current drives, you should really go with a switching regulator. The $1 SimpleSwitcher based board from ebay can be easily repurposed for this application. If you have a few spare pins on your arduino, you can also program for this purpose as well.

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131