Go Down

Topic: SdFat, bench, QuickStart, cannot get SD to run (Read 136 times) previous topic - next topic


Hi guys,
I`m really struggle here with my SD cards.
I have two 4gb cards, one is sandisk other godknows.
Any way, got them connected throught spi, no other devices are connected  yet.
Pins on my shield are shared with resistive touch, but i`m not using in in this stage.
This is what i`m getting from Serial using QuickStart
Code: [Select]
Enter the chip select pin number: 7

Assuming the SD is the only SPI device.
Edit DISABLE_CHIP_SELECT to disable another device.

SD initialization failed.
Do not reformat the card!
Is the card correctly inserted?
Is chipSelect set to the correct value?
Does another SPI device need to be disabled?
Is there a wiring/soldering problem?
errorCode: 0x1, errorData: 0x7f


Tried level shigter 4050, and tried connecting it direclty. same result expect last errorData which was errorCode: 0x1, errorData: 0x0

Both cards works fine on PC. Formatted using recommended SD formatter.
I`m using mega2560.

Thanks for any advice.

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131