But when i try Test/Query each module from Xbees Dual Shield, nothing works.
Each Module have same config.
It is so much easier to use the USB explorer to configure the XBees. Then, put them (or it) on the shield on the Arduino.Did you remove the AtMega328 chip from the Arduino (clone) before trying to configure the XBees on the shield?
This is wrong, then. Each module needs a unique address (that the other one knows about).
Please enter a valid email to subscribe
We need to confirm your email address.
To complete the subscription, please click the link in the
email we just sent you.
Thank you for subscribing!
via Egeo 16