Go Down

Topic: 1 Microsecond pulses (Read 9038 times) previous topic - next topic


Hey Mark,

Yours also works.

I am curious, did you get any overshooting with your pulse?  I was using a 60 MHz scope.


overshooting would need some inductance or capacitance...
i think both r very little inside the MCU...

maybe the wires to the oscilloscope did it?
i had that once with a 12V power cable that was connected to a capacitor via a FET... :P


You always get ringing on an unterminated logic signal into a oscilloscope probe - add 100 ohm resistor in series with the probe to vastly reduce this.  The inductance and capacitance are stray.
[ I will NOT respond to personal messages, I WILL delete them, use the forum please ]

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131