Pages: 1 2 [3]   Go Down
Author Topic: feasibility question: turning dc motor to servo?  (Read 3472 times)
0 Members and 1 Guest are viewing this topic.
Pittsburgh, PA, USA
Offline Offline
Faraday Member
**
Karma: 58
Posts: 4010
I learn a bit every time I visit the forum.
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

See if you can turn the CNC into a 3D printer instead. Then make a 3D scanner.
Logged

Examples can be found in your IDE.

0
Offline Offline
Sr. Member
****
Karma: 0
Posts: 301
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

This Arduino robot won't leave time to do that, so will continue completing it and researching needed mechanisms, thanks.
Logged

Pages: 1 2 [3]   Go Up
Jump to: