I'm getting disturbed values from both.
It clearly displays the signal's noise. When I say disturbed, it means that the signal has noise from the motors.
1. I know what an accelerometer measures. Force. I know physics.
2. Yes, the noise is caused by motors.
4. I tried already using rubber mounting on the accelerometer. I tried also the PU gel. (I got improvements, but not as much as I want)5. Do you know a better solution than all of these? I was advised some time ago to sink the board into some form of fluid which would reduce most of the vibrations. What do you think/know about it?
Please enter a valid email to subscribe
We need to confirm your email address.
To complete the subscription, please click the link in the
email we just sent you.
Thank you for subscribing!
via Egeo 16