(Read 1 time)
Oct 08, 2012, 06:47 am
Hey guys, recently I just bought a FT232RL chip from RS. So, I would like to ask, how can I connect that to my AVR chip so that I can program my AVR chip just through the USB cable ?
Any schematic ?
Location: Southern California
I like blinky lights
Oct 08, 2012, 07:36 am
What is RS? Did you buy a bare chip or a board?
Look at the Duemilanove schematic for an example of connecting them, it's not very complicated at all.
<-- My last name. Pretty apt.
Oct 08, 2012, 08:44 am
Erm, is that we just connect CCC, gnd, txd and rxd to the avr chip?
Location: nr Bundaberg, Australia
Scattered showers my arse -- Noah, 2348BC.
Oct 08, 2012, 01:59 pm
Here's the FTDI part of a schematic I used for a board a while back.
I'm not sure if it's the FT232
but I think so.
Rob Gray aka the GRAYnomad
Oct 08, 2012, 02:28 pm
So the bottom left ( DTR, TXD and RXD is connected to the atmega ? connect to which pin of atmega ?