Pages: [1]   Go Down
Author Topic: two mcu's reading off single hall sensor  (Read 520 times)
0 Members and 1 Guest are viewing this topic.
Ft. Worth, Texas
Offline Offline
God Member
Karma: 0
Posts: 591
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

hall sensor is for detecting RPM, has Vcc, gnd, and return. Not sure about the specifics, but it goes to an OEM data logger.

I'd like to tap the output into an arduino for alternative purposes. I have reason to believe that the OEM DL runs at 5 volts already, but I don't know that for a fact.

My main question, will adding another detection circuit to the hall's output effect anything?


Central MN, USA
Offline Offline
Tesla Member
Karma: 75
Posts: 7272
Phi_prompt, phi_interfaces, phi-2 shields, phi-panels
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Should be OK. Arduino input takes in very little current. I suggest you get an oscilloscope to read the sensor first, just to make sure your 5v assumption is correct.

Pages: [1]   Go Up
Jump to: