next topic »

[on:]

Guide me on how i can write and read audio,  in arduino EEPROM. Maybe Just a second,  for just an example how to start.? 

Anyone?


 

[Reply #1 on:]

Well as an arduino board lacks any real analog output I don't think it would be possible to output a audio signal without external hardware support. Reading and writing any digital data to EEPROM is a pretty simple process but recording and outputting audio directly from a arduino is pretty much a no go.

Lefty

[Reply #2 on:]

The EEPROM is also pretty small - not going to hold a lot of audio - just a fraction of a second.
There's been some nice synthesizer projects mentioned.

[Reply #3 on:]

Yes, How about it is just a few second? 

[Reply #4 on:]

EEPROM is 1K?
8 bit audio, sampled at 16K samples/second for 8 KHz max bandwidth, can store 1/16 of a second.
8 bit audio is not very good, 8 KHz upper limit also not very good.

[Reply #5 on:]

Thanks for all Reponses, and i really understand it. but i want to now how actually code it? Maybe something like:
    val = analogRead(0);
     eemprom.write(address, val);?

   maybe  PWM is equal to eemprom.read(address)?

[Reply #6 on:]

analogRead() needs 100uS to complete a 10-bit conversion. Divide by 4 to get to 8 bits.
EEPROM write needs 3.3ms to complete the write.

EEPROM read is quicker.
Standard analogwrite() is 490 Hz.

PWM output can me manipulated - this article is often referred to:
http://www.arcfn.com/2009/07/secrets-of-arduino-pwm.html