Pages: [1]   Go Down
Author Topic: DTMF MT8870 with arduino for robot  (Read 1244 times)
0 Members and 1 Guest are viewing this topic.
0
Offline Offline
Newbie
*
Karma: 0
Posts: 40
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi,
I have attached my arduino to a MT8870 like in the following diagram:
http://www.pablin.com.ar/electron/circuito/telefon/decdtmf/circuito.gif

Problem is that only one column of keys seems to work. This column changes from phone to phone- I have tested this with 2 phones.
I have not installed any pull up/pull down resistors and nor is there any buffering b/w the outputs of the MT8870 and arduino, i.e. they are connected directly. Any plausible reason why this is not working?
Thanks
Logged

0
Offline Offline
Faraday Member
**
Karma: 7
Posts: 2526
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

code? actual schematic in use?

-j
Logged

nr Bundaberg, Australia
Online Online
Tesla Member
***
Karma: 121
Posts: 8433
Scattered showers my arse -- Noah, 2348BC.
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

You should have resisters because the outputs go tri-state when no signal is present, I'd use the internal pullup ones. Buffers should not be required.

What have you got StD connected to? And post your code.

______
Rob
Logged

Rob Gray aka the GRAYnomad www.robgray.com

Pages: [1]   Go Up
Jump to: