Yes. With some "moderate" level complications.Are you sure you weren't given 88's to specifically discourage such actions?
Bet it wouldn't take much. Looks a 168 with 1/2 the memory.http://www.atmel.com/devices/ATMEGA88.aspx?tab=documents ATmega88/168 datasheet- make sure there's an entry for it in avrdude.conf - possibly copy the 168 section, update the signature bytes and memory sizes- make a new entry in boards.txt, again copy the 168 section and tweak as needed- update pins_arduino.h to call out the new type in a few placesProbably put pins_arduino.h in a new variants folder in the 1.0.1 directory somewhere.
Hello! I am working on a university project and the chips we are given by the university are DIP packages of ATMega 88. I see that these chips are pin- compatible with the 328. My question is: is there any way I can stick an ATMega88 into an Arduino UNO R2 and have it work properly?
I'd stick the chip in a breadboard and connect your Arduino Uno to it as an ISP programmer. It will work just the same and everybody will be happier.
Please enter a valid email to subscribe
We need to confirm your email address.
To complete the subscription, please click the link in the
email we just sent you.
Thank you for subscribing!
via Egeo 16