Go Down

Topic: [HELP] SPARKFUN ADXL320 Accelerometer (Read 644 times) previous topic - next topic



I'm trying to connect this sensor to my Arduino MEGA 2560, following the simple example here.

The sensor is the ADXL320 as I bought it, in it self only say ADXL3xx.

The Problem is:
When I connect it to the arduino and inspect the Serial Monitor all the readings are like 250-300 interval, and always changing but not corresponding to anything.
Not corresponding to the movement I do to it.

Maybe something is missing. Or it simple dont work. I cant tell and would like to read your thoughts about this.

Cheers. :)


Well there is not a lot to go on. My first guess is hat you made some wiring mistake. It would be good to see a photo of your setup to check you have not missed anything.


@Grumpy_Mike thanks mate.

I think i did it well, you see at the example you connect directly the sensor to the arduino.

I did that and same results, tried to connect trough wires, just to make sure, and the same result. Tomorrow I will take a photo and post here.


Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131