Go Down

Topic: DG408 wiring (Read 739 times) previous topic - next topic

srusha

Hello, I have DG408 (http://datasheets.maximintegrated.com/en/ds/DG408-DG409.pdf)

and it says in the following scheme that there is V+, V- and gnd, what does V- stands for?



thanks in advance,

silasmoeckel


Hello, I have DG408 (http://datasheets.maximintegrated.com/en/ds/DG408-DG409.pdf)

and it says in the following scheme that there is V+, V- and gnd, what does V- stands for?



thanks in advance,


Just what it says negative supply voltage.  That chip normally runs with 15v +- but supports a lot of different configurations. If you want to use it with positive voltage only connect v- to gnd as the datasheet says on page 6.

CrossRoads

If you were running from dual supply, like +12V/-12V, V- would be -12V.
If running from single +5 supply, V- goes to Gnd, per page 4.
Designing & building electrical circuits for over 25 years.  Screw Shield for Mega/Due/Uno,  Bobuino with ATMega1284P, & other '328P & '1284P creations & offerings at  my website.

srusha

Thats what I thought,

thanks for the quick reply.

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy