Go Down

Topic: Problem Web Relay Controller and Temperature Sensor Using ENC28j60 + arduino (Read 1 time) previous topic - next topic


Hey People :)
I've bought a ready made ENC28j60 board like this attached picture
and connected it to my arduino uno R3
and made a sketch to control 8 output relays and a temperature sensor
i made it from collecting some examples together
and when i upload a sketch contains only the output relays control, it works fine
and when i upload another contains only the temperature sensor, also works fine
but my problem is when i put both in one sketch . it compiles fine without any errors. but it doesn't work practically.
only the relays are working but the temperature sensor is not working and vice versa.

Please anyone could help me with this problem  :~ ??
The code is attached


"Pete, it's a fool looks for logic in the chambers of the human heart." Ulysses Everett McGill.
Do not send technical questions via personal messaging - they will be ignored.

Go Up

Quick Reply

With Quick-Reply you can write a post when viewing a topic without loading a new page. You can still use bulletin board code and smileys as you would in a normal post.

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

shortcuts: alt+s submit/post or alt+p preview