Go Down

Topic: How do I upload a sketch to an Atmega2560 from AS6 using avrdude? (Read 1 time) previous topic - next topic


I am running BOTH an Arduino IDE and AS6 IDE on a Windows XP platform. I can upload sketches from Arduino to my Atmega2560, but can't load same sketch from AS6.

The programmer listed for Arduino is USBasp.
I have tried three avrdude command lines in AS6. Not one works.
I have listed the setup and results below:

Using: id arduino
…\avrdude.conf -v -v -p m2560  -c arduino -P COM4 -b115200 -D -Uflash:w:"$(ProjectDir)Debug\$(ItemFileName).hex":i 

   Using Port                    : COM4
   Using Programmer              : arduino
   Overriding Baud Rate          : 115200
   avrdude.exe: stk500_getsync(): not in sync: resp=0x00

Using: programmer id usbasp
…\ avrdude.conf -v -v -p m2560  -c usbasp -P COM4 -b115200 -D -Uflash:w:"$(ProjectDir)Debug\$(ItemFileName).hex":i 


  Using Port                    : COM4
  Using Programmer              : usbasp
  Overriding Baud Rate          : 115200
  avrdude.exe: error: could not find USB device "USBasp" with vid=0x16c0                      pid=0x5dc

Using: programmer id stk500v2
…\ avrdude.conf -v -v -p m2560  -c stk500v2 -P COM4 -b115200 -D -Uflash:w:"$(ProjectDir)Debug\$(ItemFileName).hex":i 


   Using Port                    : COM4
   Using Programmer              : stk500v2
   Overriding Baud Rate          : 115200
    avrdude.exe: stk500v2_ReceiveMessage(): timeout


Just a suggestion. May be you can try using this commanline in studio.

-Cavrdude.conf -v -v -p m2560 -c wiring -P COM16 -b115200  -Uflash:w:"$(ProjectDir)Debug\$(ItemFileName).hex":i

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131