but do you have any ideas on how I would do the communication?
I'd probably need SPI, though how slow is slow if I wanted to go the serial port route? Also the main atmega, would run at 8MHZ so it wont be super speedy anyways...
@JoeN: I'm probably going to have them made in batches of about 50 to 100, still a bit early to know for sure.
Yup$2.43http://www.digikey.com/product-detail/en/ATMEGA168A-AU/ATMEGA168A-AU-ND/2271188Same at mouserhttp://www.mouser.com/ProductDetail/Atmel/ATMEGA168A-AU/?qs=sGAEpiMZZMvqv2n3s2xjse40PngS4U1xVADwi5G8n9Y%3d
Please enter a valid email to subscribe
We need to confirm your email address.
To complete the subscription, please click the link in the
email we just sent you.
Thank you for subscribing!
via Egeo 16