Also, can anyone tell where the buttons need to be hooked up to? I'm a novice at deciphering code.
BTW, an alternative to the RTC if you have the Arduino on your network (either with an ethernet shield or wifi) is to use the Network Time Protocol: http://arduino.cc/en/Tutorial/UdpNtpClient.
#define HT1632_DATA 6 // Data pin (pin 7 of the display)#define HT1632_WRCLK 7 // Write clock pin (pin 5 of the display)#define HT1632_CS 8 // Chip Select (1, 2, 3, or 4 of the display, depending on the ON switch)
Anyone have any ideas?