Pages: 1 [2]   Go Down
Author Topic: High precision servo control.  (Read 5249 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Jr. Member
Karma: 1
Posts: 67
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I actually have a pair of (cheap chinese) two way gimbals lying around, for 4 total channels, one of the channels has a ratchet on it, they are from a cheap chinese (computer) radio.
Pay for the shipping and they're yours.

Offline Offline
Full Member
Karma: 4
Posts: 174
The red wire is ground, right ???
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Thanks for everyones suggestions, I've actually found myself a workable solution.

I've taken a cheap joystick, and load the input values from it into an array from which I take an average value which can be used to drive the servos,

Secondly I limit the values the servos can be set to 3 degree intervals, these two techniques combined seem to produce a acceptable (but not ideal) solution.


Pages: 1 [2]   Go Up
Jump to: