Pages: [1]   Go Down
Author Topic: my dumelonove board not detecting my 328 chip  (Read 511 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 6
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

when i upload new bootloader to my arduino duemilanove 328. it shows stk resp=0x00
thennext time 0x015 etc.
is my device faulty.
how can i use my dunilanove board to a avr programmer without any hardware change.
can i upload my hex file to other avr using the same  usb cable of the arduino.
Logged

SE USA
Offline Offline
Faraday Member
**
Karma: 41
Posts: 3783
@ssh0le
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

no

the only way it works over the serial line is with a bootloader, no bootloader no load without an external programmer

if you have a chip that already works (meaning it has a bootloader) you can use the Arduino as ISP sketch in the examples, then you plug up 4 wires and go
Logged


Offline Offline
Newbie
*
Karma: 0
Posts: 6
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

im using board from
http://www.embeddedmarket.com/products/Embedded-Engineers-Development-Tool-6-0/

can u show the connection
Logged

SE USA
Offline Offline
Faraday Member
**
Karma: 41
Posts: 3783
@ssh0le
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

sure

http://arduino.cc/en/Tutorial/ArduinoISP
Logged


Offline Offline
Newbie
*
Karma: 0
Posts: 6
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

while we using ardino as avr isp then is we need to remove the bootloaded 328(in my case Duemilanove 328) ?
Logged

SE USA
Offline Offline
Faraday Member
**
Karma: 41
Posts: 3783
@ssh0le
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

no, you use the bootloaded AVR as a middle man to the blank AVR
Logged


Pages: [1]   Go Up
Jump to: