Go Down

Topic: 3 Axis CNC Controller (Read 3880 times) previous topic - next topic



I've made a cnc controller based on an Arduino UNO for my cnc mill:


  • Its not strictly an Arduino project - I've used AVR Studio 6 Assembler / VB.NET but its free, open source and uses an Arduino UNO so you might like it nevertheless...

  • Uses a wireless Logitech gamepad to manually control the machine from a few steps per second up to full speed.

  • Controls the VFD of a spindle motor with just 2 resistors, 1 capacitor and 1 optocoupler...

  • Quite fast... >>70000 steps per second...

  • Some built in commands for drilling, circles, rectangles etc. with macro editor - quite nice for simple tasks that may be done without CAM program...

More Information and sources: http://www.estlcam.com/ec_uebersicht.php

Arduino based CNC Controller / CAM Software: www.estlcam.com


Wow, that's a lot of assembler!
[ I will NOT respond to personal messages, I WILL delete them, use the forum please ]



the assembler program isn't very large or complicated - its less than 1kb (roughly 2.5% of the Arduinos flash memory).
The rest is just used for 2 ramp look up tables...

Arduino based CNC Controller / CAM Software: www.estlcam.com

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131