Go Down

Topic: 7 Segment display - help. (Read 838 times) previous topic - next topic

lost_and_confused

Folks, my old books are no longer valid.

They have chips in them which aren't available and there are new chips which aren't listed.

I want a BCD - 7 segment display driver.

I am going for a 4056.

I hope that drives "common cathode" displays.

Of course the next problem is (though I think I have nutted it out) the 7 segment display I have.

It has 4013 stamped on the side of it.  It has 10 pins.  Counting them the way you do an IC, I have determined:
1 - cathode.
2 -> 5, 8 -> 10 are the display and 7 is the RIGHT decimal point.

Pin 6 doesn't seem to be used though there is a LEFT decimal point.

I guess if running on 12v I will need 150 ohm resistors between the 4056 and the display?


Runaway Pancake


I am going for a 4056.
I hope that drives "common cathode" displays.


There's no hoping in electronics.

A 4511 will do for common-cathodes.
http://www.doctronics.co.uk/4511.htm
"Hello, I must be going..."
"You gotta fight -- for your right -- to party!"
Don't react - Read.
"Who is like unto the beast? who is able to make war with him?"

MarkT

4056 - I think that chip is specially for LCDs rather than LEDs - you need a higher current output for LEDs, the 4511 is one I used in a previous universe(!) for common-cathode displays.  Latches and does bcd -> 7seg
[ I won't respond to messages, use the forum please ]

lost_and_confused

#3
Oct 21, 2012, 01:05 am Last Edit: Oct 21, 2012, 01:13 am by lost_and_confused Reason: 1
Yeah, sorry as I think I said, my "data books" are from the 80's.

Shall have to look around a bit more.


So I shall be using a 4511.


MarkT

The "4013" marking might be related to a Fairchild FLB4013X1 - 2" by 1.2" large 7-seg display with 4 digits?  The best my web search found.
[ I won't respond to messages, use the forum please ]

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy