Go Down

Topic: Error "not in sync" (Read 369 times) previous topic - next topic

ChrisDeveloper

Can anyone tell me what:
   avrdude: stk500_getsync(): not in sync: resp=0x30
means, please?

Many Thanks,

Chris.

Code: [Select]

int num;
void setup() {
  num=0;
  // initialize serial communication at 9600 bits per second:
  Serial.begin(9600);
}
void loop() {
  num++;
  if (num==10) num=0;
  Serial.println(num);
  delay(500);
}


ChrisDeveloper

Thank you.

I very quickly got to the "your problem is beyond the scope of this guide" bit.

Rather than throw away my Arduino, I will wait hopefully for any other ideas ...
Chris

dannable

As in the diagnosis is that the bootloader is missing or corrupt?

In that case you could get another 328p-pu chip preloaded with bootloader for your particular board. Then use that to load the bootloader to the current chip? Then you'll have a spare one you can incorporate into your stand alone project!  XD
Beginners guide to using the Seeedstudio SIM900 GPRS/GSM Shield

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy