Go Down

Topic: Ethernet Capability (Read 2562 times) previous topic - next topic


It seems that the M3 chip has Ethernet capability, is it usable in the Arduino Due?


I've been using the standard Ethernet Board with the Beta release and pushing data on some watermeters I'm recording to COSM. Worked nicely and reliably.
Looking at the hardware, PB0-PB9 - the ehternet pins - are run to a connector with 14pins - labeled on the schematic MACB - but can't visually see anything on the board that specifies MAC. The MACB has no gnd or power shown - so looks like expected to be used with other pins. Neil

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131