Pages: [1]   Go Down
Author Topic: Why does PWM creates noise?  (Read 338 times)
0 Members and 1 Guest are viewing this topic.
Florida, Winter Springs
Offline Offline
Jr. Member
Karma: 0
Posts: 77
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I'm using just the audio input part of this diagram to A0 so the arduino can read the signal of my guitar and make the led strip blink.
But instead of using only one audio jack input I'm using two in parallel to send part of the signal to my amplifier and some to arduino.
The problem is when I switch to a PWM sketch, noise gets to the amplifier and disappear when the value reaches zero.
« Last Edit: October 23, 2012, 02:39:03 pm by martin_80x » Logged

Pages: [1]   Go Up
Jump to: