Pages: [1]   Go Down
Author Topic: Teensy 3.0 beta 6: enabling USB MIDI  (Read 1037 times)
0 Members and 1 Guest are viewing this topic.
Nice, France
Offline Offline
Full Member
Karma: 11
Posts: 237
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

USB MIDI is working fine with my Teensy 2, so (noticing that it is currently disabled with the Teensy 3.0 beta 6) I thought I would have a go at enabling it, to see what breaks and what needs to be changed.

I made the following changes. In hardware/teensy/boards.txt, these three lines were commented out and I uncommented them:

In hardware/teensy/cores/usb_midi/usb_private.h I wasn't sure what to add by way of a processor define, so instead I brutally commented out the following check:
// #if defined(__AVR_ATmega32U4__) || defined(__AVR_AT90USB646__) || defined(__AVR_AT90USB1286__)
// #endif

I had sort of expected that to be it; the actual code loked pretty same, with abundant use of explicitly sized types. On starting up the IDE, MIDI is there in the menu. However, on verifying a sketch which works on Teensy 2, I get

MIDI_multicontroller_USB_T3.ino: In function 'void loop()':
MIDI_multicontroller_USB_T3:34: error: 'usbMIDI' was not declared in this scope

so presumably I need to do something else to enable it. I would appreciate guidance on what that might be.

It would also be interesting to hear of any known problems with the USB MIDI on Teensy 3.0. I assume it is disabled because of known problems, though it could of course be disabled just due to not having been well tested (in which case my experiments might help).

Pages: [1]   Go Up
Jump to: