Pages: [1]   Go Down
Author Topic: Problem with TX LED  (Read 400 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 4
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi

I was happy because I can manage  make a ATmega works alone. From the advices of forum . After i made that I put the original ATmega microcontroler
back to his place (on  my Arduino UNO  socket).

Then I  tried to upload other sketch and I get the message:
_getsync(): not in sync: resp=0x00 
when i upload like programmer it told me:
avrdude: usbdev_open(): did not find any USB device "usb"

But I notice that RX led blink 3 times (somewhere read that means USB drives are OK) and TX DONT WORK AT ALL  (Ι guess for some reason dont transmit)

I  replace the originall ATmega (the one which my Arduino came ) with the one that it works alone , but the same problem appear again


PLEASE - ANY IDEA WHAT HAPPEND? 

ps : Sorry about my English  smiley-mr-green
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 4
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Ok  I am a stupid, sorry

I put ATmega with wrong orientation I saw the letters and not the mark

sorry
Logged

Tucson, AZ
Offline Offline
Sr. Member
****
Karma: 8
Posts: 312
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I would bet that most of us have done that at one time or another.  Good job figuring that out.
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 4
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I would bet that most of us have done that at one time or another.  Good job figuring that out.

I was sure that something get wrong and  my Arduino board was damage, a facebook friend told me "look  the orientation of the ATmega", and when i saw a Arduino photo in web i figure  out that i put it wrong.
 smiley-zipper
Logged

Pages: [1]   Go Up
Jump to: