Go Down

Topic: Arduino Nano TX and USB (Read 1 time) previous topic - next topic

nddery

Hi,

the TX pin on my arduino nano does not blink if the arduino is not connected via USB (but still powered on). If I plug the USB cable in, then the LED for TX start to flash. Does the led not flashing mean it is not sending out any data ? When not connected to usb, I have cable going from my TX and RX pin to my xbee.

All I am doing in the code is starting the Serial and writing to it. I stripped out everything else and it still doesnt work.

Thanks,

Nicolas

The Tx/Rx are tied to the FTDI chip on the Nano.  If you do not power the FTDI through the USB, they will not blink.  If you wish to communicate serial activity of the Atmega328 chip, then you are going to need to use the D13 LED.
http://www.spcomputing.com

nddery

Ahhhhh, thank you, I obviously did not know that!

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy