Pages: 1 [2]   Go Down
Author Topic: analog inputs  (Read 2959 times)
0 Members and 1 Guest are viewing this topic.
Germany
Offline Offline
Full Member
***
Karma: 10
Posts: 230
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Quote
but I can't see more than 10 analog inputs on the board.
.?
The board has analogue inputs labeled A0 to A11 that's twelve inputs.

In some way both wrong, there a 14 analog pins the last 2 are on TWI0 but they have Pull-ups
Logged

Manchester (England England)
Offline Offline
Brattain Member
*****
Karma: 597
Posts: 33292
Solder is electric glue
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Quote
In some way both wrong,
No I said:-
Quote
The board has analogue inputs labeled A0 to A11 that's twelve inputs.
That is in no way incorrect.
The fact that the board has a few more analogue inputs dedicated to an other function was mentioned further back in the thread.

In fact you are wrong saying:-
Quote
there a 14 analog pins
There are in fact 15 analogue pins, the 16th input to the multiplexer is the internal temperature monitor.
But only 12 are supported in the software as used by the digitalRead(pin) function.
Logged

Germany
Offline Offline
Full Member
***
Karma: 10
Posts: 230
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Quote
In some way both wrong,
No I said:-
Quote
The board has analogue inputs labeled A0 to A11 that's twelve inputs.
That is in no way incorrect.
The fact that the board has a few more analogue inputs dedicated to an other function was mentioned further back in the thread.

In fact you are wrong saying:-
Quote
there a 14 analog pins
There are in fact 15 analogue pins, the 16th input to the multiplexer is the internal temperature monitor.
But only 12 are supported in the software as used by the digitalRead(pin) function.

Yes Mike, you are right I'am wrong, my fault. I missed ADC14 on Pin52, and yes my wrong 12 supported by the corefiles from the IDE. Sorry.
Logged

Pages: 1 [2]   Go Up
Jump to: