Go Down

Topic: What are limitations of using Atmega8 (Read 5177 times) previous topic - next topic

spndr7

instead of Atmega328 as arduino's micro-controller, besides less memory ?

CrossRoads

Compare pages 1 & 2, see if anything is missing you  might want.
Atmeg8
http://www.atmel.com/Images/8159S.pdf
Atmega328
http://www.atmel.com/Images/8271S.pdf
Designing & building electrical circuits for over 25 years.  Screw Shield for Mega/Due/Uno,  Bobuino with ATMega1284P, & other '328P & '1284P creations & offerings at  my website.

DuaneB

One difference that may or may not matter to you is that the 8 has no pin change interrupts so you are limited to the two external interrupts this is easily missed when comparing the two - I know I missed it too late.

Duane B

rcarduino.blogspot.com
Read this
http://rcarduino.blogspot.com/2012/04/servo-problems-with-arduino-part-1.html
then watch this
http://rcarduino.blogspot.com/2012/04/servo-problems-part-2-demonstration.html

Rcarduino.blogspot.com


Mukhthar_Ahmed

Hello,

Internal voltage reference
atmega8 = 2.56v
atmega328 = 1.1v

regards

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy