Go Down

Topic: Arduino Chat? (Read 4672 times) previous topic - next topic

conradin

Is there an official Arduino Chat channel somewhere?
-Just curious.

CrossRoads

Folks have tried organizing one on facebook. Search there.
Designing & building electrical circuits for over 25 years.  Screw Shield for Mega/Due/Uno,  Bobuino with ATMega1284P, & other '328P & '1284P creations & offerings at  my website.

Graynomad

There is a non-offficial chat channel. Someone invited us to is here a while back but I don't remember the details. Try searching for the post.

______
Rob
Rob Gray aka the GRAYnomad www.robgray.com

justjed

http://arduino.cc/forum/index.php/topic,6037.0.html
... it is poor civic hygiene to install technologies that could someday
facilitate a police state. -- Bruce Schneier

iNishant

#4
May 18, 2015, 08:24 pm Last Edit: Jan 27, 2016, 12:23 am by Nick Gammon Reason: Modified to remove default username.
I suggest the freenode IRC channel.  This community is awesome.

(modified by admin at the request of IRC channel admins)

See below for how to connect.

pwillard

#5
Jan 22, 2016, 05:01 pm Last Edit: Jan 26, 2016, 02:27 pm by pwillard
I would like to recommend a more preferred way:

https://webchat.freenode.net/


  • Pick a nick name. Preferably one you will continue to use later as well.
  • In the Channels entry form, type #arduino
  • Ask the real questions that you actually have, since "Is there someone using xyz?" is not productive.
  • Wait until you get a reply...


#Arduino is one of the most active and supportive IRC channels.  The chances of getting little or no help are very small... but you might need to wait more than a few minutes.

To be honest... the T4NKxxx nicks drive us a bit nutty since we have difficulty making sure we are still talking to the same person.

pwillard

As a follow-up:

If you have questions about code... prepare your question by posting your code to one of the code sharing sites like:

Hastebin
Pastebin
Gist

... Just a few examples...

Suld

Hi
How to white line count code?

nickgammon

Please post technical questions on the forum, not by personal message. Thanks!

More info:
http://www.gammon.com.au/electronics

Go Up